Nautique Crossover 90490 Manuel d'utilisateur télécharger pdf (Page 157)

8-3

Clean debris from the bowl and screen and rinse parts in fresh

water. Insert the screen, place the O-ring in the groove of the bowl

and screw the bowl on hand tight. Be sure to open the water valve

before starting the engine.

Some engines are equipped with a closed cooling system with a self-

contained reservoir for engine coolant. Self-contained systems are

equipped with a heat exchanger which uses raw water to cool the

coolant. All raw water systems are equipped with a valve and

strainer.

Bilge Pumps

Check your bilge pumps often to make sure they are operating

efficiently. There are two bilge pumps: one is at the rear of the boat

near the rudder and under the floor by the forward bulkhead

located next to the fuel tank. To keep the pumps from getting

clogged, remove any debris you find in the bilge. Wash the bilge

with a good biodegradable household detergent or a bilge cleaner

available at your Nautique dealer or a marine supply store. Rinse

with water with your bilge pumps running. If your pumps seem to

lag, remove the top of the pump from the base and check the

impeller to make sure there is no debris inside. See your dealer if

there is still a problem with the pumps.

Care and Maintenance

216V Sec 8_2009.qxd:Naut Air Sec 8.qxd 1/23/09 9:16 AM Page 8-3

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 197 198

Pas de commentaire

Nautique Crossover 90490 Manuel d'utilisateur Page 157